Freudenberg Sealing Technologies is developing a new generation of conductive seals designed to ensure a durable electrical connection between housings and shafts while preventing bearing damage caused by electricity and electromagnetic radiation.

In many operating conditions, the shafts used in electric powertrains are electrically insulated from their housings. The insulation is created by the lubricating films in the contact zones for the bearing and the shaft seals. Lubrication is necessary to promote long-term system functionality.

Alternating current and its electromagnetic fields produce changes in the electric potential between the rotor and the stator and the rotor becomes charged. The current can only be drained off through a grounded system that allows the electricity to travel from the shaft to the housing.

If there is no grounded pathway, the current flows to the area of least resistance—the bearing—and produces an abrupt discharge when electricity flows from  the inner ring to the outer ring across the bearing. Discharge flashes cause surface burns and material compromises that permanently damage the system.

This results in the steady and systematic destruction of the contact surfaces in the rolling bearing. The mounting becomes noisy and the bearing must be replaced to prevent powertrain failure.

The simple solution to avoid damage from electric current is to develop a lasting, reliable electrical contact between the shaft and the housing that facilitates a continuous flow of electricity and prevents excessive build up and sudden discharges.

The more difficult challenge is to find a system element that can conduct the current via ongoing contact with both the housing and the shaft. As a rule, seals are made of insulating materials and are not suited for this purpose.

For several years, Freudenberg Sealing Technologies has been producing an electrically-conductive non-woven disk as a series-production system element.

The disk is firmly connected to the shaft seal ring and requires almost no additional installation space. The conductivity of the nonwoven is achieved with special fibers that are embedded in a matrix.

The system has been used in regular-production electric vehicles for years and reliably prevents bearing damage. The electric resistance in this approach is already at a very low level, but the sealing specialists at Freudenberg Sealing Technologies continue to develop the solution further.

Power densities continue to grow in upcoming electric powertrains, increasing current, voltage and disruptive electromagnetic fields.

To offer a robust solution for these situations, the company is now developing a new generation of conductive seals. The first validated, functional models in this category will be available within a few months.

Our goal is to achieve constant resistance values over a long period of operation – even in adverse conditions. —Dr. Tim Leichner, responsible for Strategic Product Advance Development at Freudenberg Sealing Technologies

To fulfill the new requirements for seals in electric powertrains, Freudenberg Sealing Technologies has developed the appropriate test procedure to evaluate and compare the functioning of current dissipation elements.

Test stand trials have shown that static measurements of the elements’ electrical resistance are not adequate to predict electrical conductivity during actual dynamic use. As a result, development engineers in Germany developed a dynamic testing procedure that delivers alternating-current flows in the frequencies found in automobiles.

There is the possibility of doing even more with conductive seals. High electrical conductivity lends itself to possible shielding of disruptive electromagnetic radiation.—Francois Colineau, in charge of the development of this product line at Freudenberg Sealing Technologies

The exit point of the shaft from the housing, in particular, is normally a location where “impermeability” is only achieved with difficulty. At this location on every electric motor, there is a shaft seal that could help handle the shielding. It would be possible to combine the sealing of oil and other media with impermeability to electromagnetic radiation – without necessarily adding another non-woven layer.

Posted on 20 September 2019 in Electric (Battery), Motors, Vehicle Systems | Permalink | Comments (0)

The comments to this entry are closed.